Hi Bob,
We have installed Multipathing software called Powerpath from EMC on these 11iv3 clients.
Because of which the paths might have changed.
How do we ensure that this scanning doesnt take the same ammount of time always .
CM is Win 2008 R2 .
Clients HPUX 11iv3 .
How do we enable Persistent Binding on your Network Switch Router (NSR) ?
We are using MSL 8096 tape library , DP 7.03
One more observation is we can see that all clients are configured in hp msl g3 ROBOTICS properties.
Is it necessary to configure all clients ?
Or it must contain only one CM entry in it ?