Hello
You must go to object opeartion and use object copy feature
Copying Objects Interactively
After an objectCollapsed has been backed up, you can copy it to a new media set.
You can select objects for interactive copying from the Media, Objects, or Sessions starting point, depending on your needs. You cannot save an interactive object copyCollapsed specification, you can only start an object copy session.
Steps
1.In the Context List, click Object Operations.
2.In the Scoping Pane, expand Copy, then Object copy, and then Interactive.
3.Click Media, Objects, or Sessions to open the wizard.
•Clicking Media lists media pools and media.
•Clicking Objects lists types of backed up data, such as Filesystem, Database, and so on.
•Clicking Sessions lists sessions in which objects were written to media.
4.Select the objects to copy.
If you selected Sessions in the previous step, you can right-click an integration objectCollapsed and click Select Backup Set to select all integration objects with the same backup IDCollapsed.
Note: From Data Protector 9.05 onwards for VMware backups, the virtual machine disks are considered as objects that run in parallel. The disk objects of the virtual machine are listed but disabled in the Media list to understand virtual machine disks backed to the media. The copy or verifyCollapsed operation is performed on the virtual machine objects and all its associated disk objects are considered internally.
From Data Protector 9.05 onwards for VMware integration, the Next option is enabled only after selecting the virtual machine object in the Media list.
Click Next.
5.The devices used for writing the selected objects are used as source devices in the object copy operation by default. You can change the source devices here if desired. Select the original deviceCollapsed and click Change. The name of the new device appears under Device Status. The new device will be used only for this session.
For more information on a device, right-click the device and click Info.
Specify what Data Protector should do if the selected devices are not available during object copy (for example, if they are disabled or already in use). Select either Automatic device selection or Original device selection.
Click Next.
6.Select the destination devices for the object copy operation.
You can specify devices per object in the Summary page from the list of devices specified here. If you do not specify a device for each object, Data Protector will select the most suitable devices from this list.
Click Next.
7.Specify the source object options, target object options, and target mediaCollapsed options as desired. Click Next.
Optionally, to enable replication between two B2D devices instead of copying, select Use replication. Once Use replication is selected, the Replicate to a foreign cellCollapsed gets enabled.
8.A list of media containing the selected objects is displayed.
If your starting point was Objects or Sessions, media location priority is also listed. You can change the media locationCollapsed priority to influence the selection of media in case the same object resides on more than one media setCollapsed.
Click Next.
9.Review the summary of the selected objects. To change options for a particular object, select the object in the list and click Properties.
You can specify source object options, target object options, and the destination deviceCollapsed. If the Objects or Sessions starting point was used, you can manually select which copy of the object version will be used if more than one copy exists.
10.Click Finish to start the copy session.